PWM3 connections

[Bob Boyce]

Hello all

Sorry I have not been on sooner. Between my wifes health and my own health issues, I am going through a lot right now.

Renaud, I had received your email response about the PWM3E update, but have not received any about the toroidal connection information. Your last email was sent from a hotmail account, so I cannot send you the information you ask at that email address. If you will send me an email from an ISP type email account, then I can help you.

If you read the fine print in the contracts of most free email providers, by using their service, you are agreeing to give them license, or ownership, of any content you send or receive through them. Since the fine construction detail and connection detail of my toroid are not in the open public domain, sending this through such an email provider is not in my best interests.

I do not mind sending out the toroidal information, as long as I have the time to prepare a drawing for sending. Every drawing sent out to other experimenters is electronically serialized, and is registered for use by that particular experimenter. If a leak does occur (such as the sharing of the file), I can determine the source of the leak by this electronic serial number. This is why I have discouraged the sharing of this particular file amongst experimenters.

Bob

[emmett]

Hey Bob, can ya squirt me one too? Good to hear from you sir!

[jjbeamish]

Hi Bob,
I hope things are managable. I do not post much but would like a copy as well. jjbeamish at frontiernet dot net

[Palic]

Sorry to bother you Bob
Can you please send me the copy
of the toroidal conection information.
Than you

Palic

my email is: vilidudas at sksyu dot net

[Bob Boyce]

[Bob Boyce]

[Bob Boyce]

[randut]

[frisebyne]

[Looking In]

[MarkinAustralia]

[thrmlevnt_dave]

[Bob Boyce]

[ElectroGasMan]

[ElectroGasMan]