Bob's Booster w/ resonance

[crazycorkey]

[crazycorkey]

Is there a reason why my post was ignored? Did I say something stupid?

[weggl]

Crazycorkey, give it a little time, some are busy.
There you have your first response.
weggl

[MarkinAustralia]

Hi,
after 34 flights (12 international) this year, and a lot of road miles in the USA I am finally home for couple of months (baby due in 3 weeks).
I was hoping to have completed a lot more research by now but unfortunately the last company I worked for was not up to my ethical standards. I have had a bad run with not so honest business men in the USA.
However the good news is a new research facility with Dyno's etc will be established with good people and clean money in the next two months. This will be made available freely to those people who ar genuine about this research.
I have been side tracked also on some other project centred around emmisions reduction.
I was also disapointed with the nano technology I investigated, and most of the cells I had built, or tested all were no better than faradays.
I have stated in the past, and I still stand by it, that I believe Bob Boyce is the only one to achieve better than faradays although I believe Stan meyers may have on a smaller scale. However stans technology (replicated by dave lawton) is difficult to scale up. I also believe Alaskastar has a concept that is workable but needs to be tested.
On my return I will be testing to see how many litres per minute are needed per HP and to see if its possible to run an engine on water.
As well as seeking out a working better than faradays cell (Hypowerfuels claim they have one too...but no proof yet) I will also be using high efficency alternators and using thermoelectric to recover the waste heat and turn that to hydroxy as well.
I owe a lot of thanks to Bob for his good advice.
i lost contact with a few people who phoned me over there..my skype address is mark dansie and you can email me so I can phone you all back.
I had some bad times with some of the business people I had to deal with and even worst times with people who feel its in there best interest to keep me quiet. This has been very stressful emotionally and I dropped of the radar altogether for a couple of months until I returned home.
My first call when I return will be to Bob (I still owe you a steak dinner)
I would love to meet those who have got 5x and 10x using Bob's technology but fully understand Bob's comments as I wouldnt want to wish anyone what I have been through and I know others who have been through a lot worse.
However now I have the right team in the USA and sufficient funding, I hope to make rapid progress on my return.
i will share freely all test data.
Keep up the faith
Mark

[crazycorkey]

thank you for the replys

Any info on the silver coated copper core teflon wire. I can't seem to find it.

[NoahCount]

[quote="crazycorkey"]
Any info on the silver coated copper core teflon wire. I can't seem to find it.[/quote]

Alpha Wire makes what you are looking for. The Alpha part number for #22 is 2855/1, for #18 it is 2857/1. It is sold in 100 or 1000 foot rolls.

One Alpha distributor is Newark Electronics at www.newark.com You should be able to search their web site for the above part numbers for price and availability.

Good luck!