Motorcycle on HHO

[BroBob1]

[resident_genius]

[BroBob1]

Well! I tried the vacuum port and I could not shut the engine off fast enough, it was sucking the water right out of the bubbler
The only thing left is to try a "Y" fitting in the fuel line after the fuel pump

[resident_genius]

hmm. i can think of one solution. lemme draw it up real fast.... for the two carby model, id require three "Y" splitters, and for the four carby model, it'd need seven "Y" splitters.


on second thought, with that vacumm leak there, you would be asking for a tuning nightmare. try draining some water out of the bubbler, or adding in an inlet on the top of the electrolyser. lemme draw that one up.....

[BroBob1]

[resident_genius]

hmm. that would work too, good thinking! sometimes the best solution is also the simplest, haha.

[BroBob1]

Had to add a regulator to one of the 4 HHO Gens for it to work properly.
So I have a valve at the top of the Bubbler and an air regulator on the top of #4 Gen ( I have 4 hooked up in series), and with them adjusted just so, with a certain amount of water in my 2' long bubbler ( a little less than 1/2 full) it seems to be working pretty well.
Put 50 miles on it yesterday and it's running very good. Have not checked gas mileage yet.
More to come!!