Hi Guys...have I got this right?? the H comes off the -VE plate(s) and are the small bubbles and the opposite for the O??...
I have just built a version of Smacks Booster and as I was testing it before putting it in the vehicle I decided to revers the polarity, ie. I put +VE to the centre plates and -VE to the outside plates, well it appeared that the gas production increased significantly BUT this may have been an increase in O and not H, which presumably is not what is needed, any comments on this??...
I am using KOH at 1.25% solution by weight in distilled water, I seem to recall that when I asked the question about % solutions earlier, someone said that they used 26%, is this a bit over the top?? and when you use a 'stronger' solution do you get more gas??...
I also initially ran it direct from the battery at about 11.8v, when I switched to running the + cable from the back of the alternator at about 13v the amount of gas generated seemed to increase significantly, so is there an easy way to run the generator at, say, 18 or 24v from a normal auto system?? as I presume this will make huge amounts of gas???...
Getting there, slow but sure!!!...thanx in advance for all your help...kind regards dizzy