peterZA, Welcome to OUPower. Never let the plates go low. And as always Please use caution. Have very good ventilation. Remember to use a non Iron sand paper. Rinse with distilled water. And use a new pair of clean pliers to handle the plates. don't dry them!! put them in the cell box wet. Keep all your stainless steel separated from all contaminations. Dust, steel work bench, c-clamps, dirty work bench, oils, fingers prints..
Keep in touch, let us know how it is going
Electrolyte lower level in a series cell welder
2 posts
• Page 1 of 1
Electrolyte lower level in a series cell welder
by peterZA » Sat Oct 20, 2007 3:58 pm
- peterZA
- Posts: 9
- Joined: Wed Oct 03, 2007 4:38 pm
- Location: Cape Town, South Africa
Re: Electrolyte lower level in a series cell welder
by Looking In » Sat Oct 20, 2007 4:42 pm
Rich (Looking In)
((((Is it really so difficult to tell a good action from a bad one? I think one usually knows right away or a moment afterward, in a flash of regret.)))) BOOM
((((Is it really so difficult to tell a good action from a bad one? I think one usually knows right away or a moment afterward, in a flash of regret.)))) BOOM
- Looking In
- Regular Poster
- Posts: 367
- Joined: Thu Dec 22, 2005 11:06 am
2 posts
• Page 1 of 1
Return to Hydrogen Production via Electrolysis
Who is online
Users browsing this forum: No registered users and 30 guests