resonating water... length of resonating tubes

[Goofy]

The classic way to heat up tapwater is using a heat exchanger is not so difficult to determing the needed power to heat up the water, depending on the flow rate of the water.

Heating up water with switching voltage directions where the water molecules cause friction is ...on the theroretical part less obvious.

So is there way to determine the lenght of the resonator tube(s)?

Or is it more safer to do a trial and error method.

[kevinsatterfield]

[Goofy]

[Goofy]

[Goofy]

[kevinsatterfield]

One of those videos of Stan talking to an aodiance a black guy asks him a question, the aoudio isnt very good and the question cant be heard ...at least by me, but Stans responce was " yes we figuired out if we switch back and forth" and another video of Stans water tank somebody pulls out a tube that looks like to be a 2" s.s. tube with rectangle slots spaced the length of the tube....I think the same video shows the steam resonator with the cover being placed on with just a brief glimps partially of the inside and it looked like some sorta resonate chamber like a magnetrons or someth'n... info on that steam resonator wuld be great.

[Francois]

[Francois]

[RunningBare]

[kevinsatterfield]

[RunningBare]

[kevinsatterfield]

[Francois]

Hi all,

How to determine the capacity (F) of the pipes so as to
to tune the tube units et coils on 42.8 Khz?

If we take the frequency of 42800 Hz like reference (See also Dr Puharich)
then one can modify both the coils and the pipes lenght consequently
(since most of the time each one has lengths tubes different.)
The Ph of the water can be different.

What is your opinion about that ?


Thank.

François.

[kevinsatterfield]

i took referance to Stans patent that says a typical 3 inch cell resonates at 5Khz.I added 5Khz to every 3 inches of pipe till i got close enough to 43Khz and devide that by 1/2.Pluss I added an inch for the bottom and im still decide'n on if the inch is gonna be enough.Im looking for a 5 or 6 inch diameter conainor at the moment myself so's ya have good questions there.... wish somebody culd give an educated answer.

[Francois]

Hi all ,

I found many differences on the web ...but never mind :

On PESWIKI:

42712.2Hz: Keely's water-disintegration frequency -> you're dead
42800 Hz: Aetheric dissociation/water resonance (water -> aetheric force)

Meyer Stanley / Dan Danforth :

43430 Hz 143762 HZ
SUBHARMONIC SUBHARMONIC
1st 21715 HZ 1st 71881 HZ
2nd 14476.67 HZ 2nd 47920.67 HZ
3rd 15517.5 HZ 3rd 35840.1 HZ
4th 8686 4th 28752.4 HZ

*1500 VOLTS IS THE MINIMUM REQUIRED FOR MOLECULAR RINGING TO BEGIN.

I found these values very interresting to test.

François.