Tune-Up in prep for booster install.

[readyakira]

I was wondering what companies/products you all are using for your tuneup parts. I have a 98 s-10 with a 4.3 v6 and notice on wet moringings the truck misses a bit when cold. So, in prep for installing my series booster, I plan to do plugs wires, cap and rotor and probably coil on my truck. I wanted to go with some products that should help imporve gas mileage, and maybe be benificial when running HHO booster. Any Ideas?

[fixaze]

I'd look for forums where people discuss this truck and motor and go with what they recommend?

Sounds like all new ignit stuff...check the choke...check the O2(s)?

[readyakira]

Well, it only happens when it is cold. And it is fuel injected so it is not a choke problem O2 sensors should not be in use at that time either. which leaves basicly an ignition problem because the computer shouldn't be using all of the sensors at first startup. Anyways I have some posts out in a few places just trying to see what people have used.

[fixaze]

No choke...but you need your O2s to cycle when hot?

I'd probably try NGK v-power plugs and spiral core wires. Clean the injectors and check all the other sensors. Basically a full tune up.

Then I'd flush the oil and change it using an additive. Do a carbon clean using water or seafoam. Change out/flush the trans/diff oil and use an additive. Up the tire pressures some...to the point your truck will corner and not slop.

Then I'd go racing....