I sketched up this design of mine in paint for your thoughts.

I'm new in here & I've only read a few posts so far. Amazing site !
I noticed pulsing the power & I thought extra vibration might help ?
The picture of the spiral springs on the left is just an example.
I would make the coils using 5mm 316 austenitic s/s wire & make the
coils spiral up with only an 8mm gap between the wire.
This will cause magnetism due to cold working the s/s.
I'll deal with that after 2 more step in the coil making.
I'll cut the lengths of wire & get them industrial beed blasted.
A friend has a demagnetising bed that I'll roll them on to draw it out.
These coils will have 3 studs welded at 120deg apart as low as I can.
Holes to match these studs will be drilled on the outer shell.
All the coils will be stacked & locked, but can vibrate individualy.
The centre filler tube will be smaller in dia & will allow the vibrating.
Rather than type anymore now, I'll hopefully get your opinions on
this gen. Just remember I'm new in here. So be genttle on me pls.
Cheers !Statistics: Posted by Hybrid — Tue May 20, 2008 9:40 am
]]>