Before I install my electrolyzer in my car, I have to condition the plates. I have read various ways to do this and would like to form a list or method of conditioning plates.
here is what I have so far:
1: sand plates in criss-cross pattern.
this forms micro-mountains on the plates increasing surface area of the plates
2. let plates sit in solution of NaOH(about 10%) and HOT(almost boiling) water until water reaches room temperature.
this cleans the plates
3. rinse with distilled water.
this removes caustic material from surface of plates
4. let sit in distilled white vinegar for 12 hours.
5. rinse with distilled water.
6. set polarity of plates by wrapping wire around plates. and touching to battery. mark plates so they are assembled in the same order.
electrolysis is not just an electrical process, but it is also a magnetic one
7. assemble cell being careful not to scratch plates
8. let cell run for.....this is where I need help!
i dont know how much power to apply, or for how long, what to look for or anything like that.
What i believe you do, is run the cell full power until brown scum stops forming. this means the iron has leached out of the stainless steel so it is more corrosion resistant.
please help me with this process. It will help me and many others without the knowledge of this process.Statistics: Posted by JimTech — Sun May 09, 2010 2:39 pm
]]>