]]>
]]>
]]>
Have you made this circut? I'm not sure how I'm suppose to wire the transformer. I know the guage and the number of turns but what do I do this on? Should I get a transformer and strip the wire from it and re wind it?
Thanks,
-Randy
Statistics: Posted by Etownlax — Sat Oct 21, 2006 3:10 pm
]]>
The simplest way of doing this is with a relay. Set up the relay coil to be fed through a Normally Closed (NC) pair of contacts.
To do this:
1) Connect the common from the relay contacts to one end of the coil.
2) Connect the other end of the coil to the negative on your battery.
3) Connect the positive of the battery to the NC (Normally Closed) contact.
The relay will now start buzzing. They don't last a long time doing this, but it is fun to try.
Now connect the primary terminals of your transformer in parallel with the relay coil.
Measure the voltage on the secondary terminals of your transformer.
Voila!
Statistics: Posted by nebbian — Sat Oct 21, 2006 11:20 am
]]>
Anyway In this site you have various schematics
http://www.eio.com/repairfaq/sam/samschem.htm
I gues you need a 12V dc to 220V AC at about 150W
look at this site looking for : Basic 200 W power inverter
Hope this helps
Statistics: Posted by Palic — Fri Oct 20, 2006 11:06 am
]]>
]]>