Also, let me get this straight, in order to most effectively generate Brown's Gas for an automobile, one would need to;
1) Use an AC Inverter or re-wire Alternator to produce 110 V AC
2) Contruct PWM3F and Toroid for 110 V AC input
3) Output from Toroid to endplates of 70 plate box. 70 plate box has 6"x6" squares spaced (??)mm apart and an autofil for lost water.
This set up generates 15LPM hydroxy, Using 15 amps or less, and is sufficient to run a small engine provided you use water mist injection to control detonation and either don't mind the rust or use stainless. Also, will need to adjust timing and/or fool computer to adjust timing.
Is that right, or am I combining information from posts that was not meant to be combined? Also, it is assumed that there are safety devices and blow out plugs and the like.Statistics: Posted by Graham — Fri Feb 09, 2007 2:45 pm
]]>