magnetolysis Project Page 1

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: August 18, 2009 10:44am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from mzk

Click Here to Re-Display the Main Project Page

Project Description:
Hello. I wound today my magnetolysis pipe - 4 layers 24 AWG.
The problem- the coils have different turns ratio. I have no idea what will happen with the reactance of the different coils, but I hope this is not a problem for now.

I have connected the coils in parallel. Ohmic resistance - 1 ohm.
The coils lenght - ~28 cm
Turns - +/- 20 turns each coil; about 280 turns each coil.
24 AWG is 0,4 mm thick, I hope 4 layers will carry several amps.

My drive is 4093 IC with BU508 bipolar transistor. Frequency and DTC depend on trimmers and capacitor. I can try it with IRF540 however.

Not tested yet. I'll use KOH.

Later I'll try this thing in series resonance mode.

Sorry... No description for this picture at this time.
The picture name is: img1.jpg
Sorry... No description for this picture at this time.
The picture name is: img2.jpg
Sorry... No description for this picture at this time.
The picture name is: img3.jpg
Sorry... No description for this picture at this time.
The picture name is: img4.jpg

Click here to continue Drilling into Projects from mzk
Click Here to Re-Display the Main Project Page
This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: August 18, 2009 10:44am v7.01
WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!
Click Here to go to my YouTube Channel!!
Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!
Click Here to go to our ARCHIVED Discussion Boards.
Please consider donating to help support this website!