Site Message:
WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Project Owner's Warning:
Hey Boys,
I may have come up with something here. This unit has 15mm of epoxy above the plates and has a manual float valve water feed. There does not appear to be any current leakage, if there is any it is minimal.
I had run the unit and let the electrolyte level drop to below the top of the plates, the current was 10 amps I then added water to 1/2” over the top of the epoxy and had no current variation except for a fall of about3/4 amp after a minute, due I believe to a drop in temperature. This recovered in about 3 min to 10 amps as the temp rose.

I intend to use the water fill tank as the bubbler, which means that sodium hydroxide vapour will congerate in the bubbler which in turn will re-circulate to the cell reducing the need to top up electrolyte. The tank will have a blow off section.

Will do some yield test tomorrow after I get the top cover installed.
Will post results tomorrow.

Warren.

For the reasons stated above, the Project Owner felt it was necessary to Caution you before allowing you to view this project.
You will be asked to re-acknowledge this caution message every 30 minutes while viewing this particular project.

Do you agree that you:
     1. Fully understand the Site Message at the top?
     2. Fully understand the Project Owner's Warning for this project?
     3. Fully accept all responsibility for your actions resulting in your viewing of this information?

Type I Agree ONLY if you agree to ALL 3 points above:


Click here to continue Drilling into Projects from weggl

Click Here to Re-Display the Main Project Page