Welcome to OUPower.com
"Over Unity Power" Research

1st project Project Page 1

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:37am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from rnorr002

Click Here to Re-Display the Main Project Page
Project Description:
this project i wanted to utilize a ss coil around a solid bolt which would be used as the positive electrode... the spring i found is ss i am not certain of the grade and the bolt i though might be but after running it in the machine it does not seem to be... i was able to fill a small water balloon from about ten minutes of running and the machine did not get too hot.. my next step is to hook up a bubbler so i can count the bubbles to get an idea of how much i am producing... ok the bolt i used most have been made of an alloy of some sort that did not like the electrolysis it tunred black and had a 1/8" of ? built up on it... and it slowly produced less and less gas... so i guess i need to find a better center post and try it from there...

Proceed to another page of the 1st project Project: [<<<   <      >   >>>]

this is the machine doing its thing... the power supply is a 12Vdc power converter putting out around 600mA... at this point i have not added KOH i just wanted to see if it would even work and how well it would with the bottled water

this is the two electrodes assembled in the cap of the a gatorade bottle... the spring is the negative terminal and the little wire coming off of it goes out the lid for the connection... the positive terminal is a bolt i found that is pushed through the top and it is all sealed with two holes and the cap assembly with two part epoxy (hysol)

this is just a pic of the bottom of the cap assembly before i gobbed hysol all over it...

this is another angle

the cap fitted to the bottle i could not get it to seal properly so i added hysol to the threads to get a water tight seal

Proceed to another page of the 1st project Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from rnorr002

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:37am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!