Welcome to OUPower.com
"Over Unity Power" Research

low volt high amp dual chamber Project Page 1

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: January 11, 2009 11:27pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from resident_genius

Click Here to Re-Display the Main Project Page

Proceed to another page of the low volt high amp dual chamber Project: [<<<   <      >   >>>]

kinda messy.... not my final draft here, but let me explain. the two chambers here are wired in series. they are hooked up with a tube that balances the levels, and the output tubes are simply joined for ease of use to bubbler. bubbler is the small container all the way to the left. the tube then vents to the outside of my house, as running HHO generators indoors for extended periods can make you nervous, especially with a 8+ month pregnant fiance and a two and half year old walking around.

the driving apparatus was a 13.8 DCV, 3 amp power supply. this then powered....

my 0-5DCV, 93% effecient dc-dc power converter. this was at the time tuned to about 5.0 DCV, so each cell got 2.5 DCV, and as you can see....

....it was pulling about seven ampheres.  the production of this cell, using four plates each, eight in total, and pulling seven ampheres almost matched the performance of my delta cell, which i eventually turned into the "Quad-Cell".....quite obviously by adding another set of plates and making it four-sided. the quad cell, brute force, being hit with 25 ampheres and 5.0 DCV in a single chamber, had almost the same production as two small chambers, half the voltage, and less than a third of the amperage.  as mrgalleria will tell you- "cell design is KEY!"

just another picture. IR thermometer pictured, priceless i tell ya.

Proceed to another page of the low volt high amp dual chamber Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from resident_genius

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: January 11, 2009 11:27pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!