Welcome to OUPower.com
"Over Unity Power" Research

installed in car Project Page 1

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 27, 2009 11:13pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from resident_genius

Click Here to Re-Display the Main Project Page

cell driver.....12DCV in, 7 amps in (approx), 0-4 DCV output, 40 amps stable. four small squirrel cage fans blowing on the converter to keep it cool.

another shot of the control box. 12 V 20 A capable guarded switch. again, with it being a one-wire setup, the little green lights cant work without a wire going to ground.  so i just joke and say they represent "green power" haha. the fuse holder is 15A capable with a 15A power fuse in it. this is my "emergency backup kill" setup. output to this goes into cell driver.

case shown with cell inside.  as u can see, theres a hole drilled and the output tube comes straight up. the one terminal has two lugs on it cause its a common ground.

0-25 amp meter. soon to be replaced with a 0-40 amp meter.

okay.... the clear container is just in case the cell cracks, i dont want ultra strong distilled and KOH spilling all over my benz's interior.   the ammeter isnt mounted in the case like it will be since it doesnt go high enough (40 amps). the cell driver is to the left in with the three wires coming out of it.  the little guarded switch is a handheld controller that can be easily accessed since theres extra wire. thats the main safety switch...the cell is controlled to ignition hot, but i can manually shut it off if i want to.  the two little green lights dont work, i was going to make two-wire setup and that would've allowed it but, now i just joke and say its "green power" haha.

Click here to continue Drilling into Projects from resident_genius

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 27, 2009 11:13pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!