Welcome to OUPower.com
"Over Unity Power" Research

This is a little jig that I made so I could get consistant spacing on my little stainless rectangles. Another jig picture. The shim stock laid out, with the little rectangles.  I abandoned the jig because of how quickly the cutoff disks "eroded away".  I think if I had any of the fibreglass reinforced ones, it would've worked out much better. To cut 15 or 16 plates, this is how many disks I went through (and don't forget about those that bounced harmlessly off my safety goggles. This is the end of this project.  I am unsure if I'll return to it. I ended up trying out a series cell design, and think I'll stick with that... For now.

Click here to continue Drilling into Projects from nakros Click Here to Re-Display the Main Project Page This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!) This Project was last updated on: September 25, 2006 10:37am v7.01 WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK! Click Here to go to my YouTube Channel!! Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board! Click Here to go to our ARCHIVED Discussion Boards. Please consider donating to help support this website!