Nitrogen Hydroxide Cell Project Page 1

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: May 3, 2009 12:50am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from mrgalleria

Click Here to Re-Display the Main Project Page

4 1/4"x 12" cell, and 1 1/4"x 10 1/2" cell.
End plates for 4" made from Wal Mart cutting board
cut on drill press. Wire is 12 or 14. Drip emitter
is used to adjust incoming air caused by engine vacuum.
The 4" cell goes on a '95 Subaru.
Topic of discussion for this design here-
http://www.oupower.com/phpBB2/viewtopic.php?t=2389
Original design here-
http://www.hydrogengarage.com/pdf/d18.pdf
More info-
http://www.cyberspaceorbit.com/indexfuel.html

This is the inner collar which is a friction fit
with the inside of the outer tube.
The inner tube fits inside of a groove which keep it centered.
The inner tube is about 1 1/2" shorter than the outer tube,
and about 3 1/2" outside diameter. 5/16" allthread S.S. bolt and S.S. hardware.