Welcome to OUPower.com
"Over Unity Power" Research

Motorcycle Brute Cell Project Page 1

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: May 24, 2007 11:32pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from mos68x

Click Here to Re-Display the Main Project Page

Proceed to another page of the Motorcycle Brute Cell Project: [<<<   <      >   >>>]

This is the motorcycle that I will be doing my work to, a 1997 Suzuki Marauder VZ800. There is plenty of room aft of the V-twin engine, but above the output shaft of the transmission. In that spot in this picture and the one below you should be able to see the stash tube that normally carries papers and tools. That is the spot where I'll put the main chamber, since the stash tube is 2.75" in diameter it'll be a tight fit, but I can get the chamber in that spot.

Here you can see the left side which is a little "light" visually. The "empty" area on this side will be used by the two bubblers that I have planned.

Sorry... No description for this picture at this time.

The picture name is: 0402070937.jpg

This is the sealing clamp that I'll be using on the chamber so that I can fully remove the plates to do maintenance on them.

These are the end caps that I bought at www.mcmaster.com , along with everything else that I have used in this project, with the exception of the tubing which I bought at www.onlinemetals.com.

Proceed to another page of the Motorcycle Brute Cell Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from mos68x

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: May 24, 2007 11:32pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!