Series Cell Project Page 1

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: August 3, 2007 12:49pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from hydrodude12

Click Here to Re-Display the Main Project Page

Project Description:
This is the new series cell that i am working on. I was doing a small cell before in a 1" PVC pipe, but I found out from Bob that I was not on the right approach. So, I decided to start making a series cell.

These are the Stainless steel bolts I am going to use.

In the picture, you notice that one is shorter than the others; when I got the bolts from the store, that short one was in the wrong bin.

So when I get a chance, I have to go back and get the right bolt.

A shot of the acrylic pieces I am using for end plates. The place i got these from only went up to 1/4 inch thick, and I wanted 1/2 inch thick. I just got 4 of the 1/4 inch ones, and i'll put 2 on each side to make 1/2 inch.

Another angle showing the thickness. Sorry about the glare.

Here I am marking the holes to drill on the acrylic pieces.