combo cell Project Page 1

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:37am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from adam666

Click Here to Re-Display the Main Project Page

1 set of plates (7 cells) currently installed. should be room enough for 3 sets total. 3 x 7 cell series running in parallel.

plates are 100mm2 , less 2-3mm on 3 edges

plastic container has 4 latches, a rubber seal, and a volume of 2.2l

slotted plastic is a old plastic cutting board I had lying round. not sure exactly what its made of but works well for tin can stirling bearings too

smells quite waxy when being cut.

Frame re-slotted - not capable of holding 3 x 7cell series cells
adding another 14 plates to the existing 8

slots made with a hacksaw :p Ill be finding a bandsaw to use next time!!

1st cell in place. Have run a small bead of hut glue along the bottom of each plate.
try to prevent and plates shifting. not overly successful