Welcome to OUPower.com
"Over Unity Power" Research

Testing Bobs Design Project Page 1

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: October 9, 2006 10:14pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from Nerd_Weed

Click Here to Re-Display the Main Project Page
Project Description:
This is my setup to Bob Boyce concept of electrolysis.

Proceed to another page of the Testing Bobs Design Project: [<<<   <      >   >>>]

My brother in law works in a petrolium extraction company and they have a part that takes this disc cut so a tube can be attached to the SS Plate. He gave me 21 plates cuted with lasers.
They are 302 Steamless Steel with 3 3/4" diameter 1,5mm thick.

this is where the laser started to cut from inside the disc. They would throw this disk away or use in an eventual case to make a smaller part.
My brother in law told me that they have lots of these disks and if this cell works he could get me more discs.

Those will be the bolts to suport the discs. They will be insulated with this Nylon spacer. The bolt is a 304 SS and will not touch the disks. I'll use this setup to test bob's design, but if use a SS spacer + Nylon Spacer i can use one bolt for + and another for - if you got the idea. If you didnt, i'll show latter with more photos.

Just to test the pressure... its amazing when you go in those far places to buy your material. I was charged 22 bucks for the 1meter bolt and 60 for this pressure meter near my house and when i went in the suburbia i bought the bolt for 8 bucks(+3 to cut it) and 15 bucks for the pressure meter.

This is the structure to the cell.
Three 6" long x 1/4" diam SS bolts, 2 plastic bases, SS nuts and Nylon spacers

Proceed to another page of the Testing Bobs Design Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from Nerd_Weed

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: October 9, 2006 10:14pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!