Cell Testing Project Page 1

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: October 26, 2006 07:34pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from H2o

Click Here to Re-Display the Main Project Page

These 3 cells are in the middele of a 100 hr run.

This is after 100 hrs running, The 3 cells vary a bit but thats due to my lack cleaness, No noticible wear on the electrodes,Even tho there should be a little bit of wear at the start it would appear to be clean

Here is a 4 cell,running 12v@.5a each cell is cunsuming 1.5w/h. These 4 cells i have had down to a voltage of 0.675@10mah per cell thats 0.00675w/h. Not much gases but still gases forming but what do i expect at 10mah.

Here is a close up of the 4 cells running still 12v@.5a, Have not measured gas output yet.