Welcome to OUPower.com
"Over Unity Power" Research

Large Bell Stack Project Page 1

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: November 18, 2006 12:39am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from Beshires1

Click Here to Re-Display the Main Project Page

Proceed to another page of the Large Bell Stack Project: [<<<   <      >   >>>]

Beginning the Bell Stack. Because the bottom outer edge is rounded, I had to drill a 1/16 hole in the center of the bottom rim. I placed the dish with the 1/16 hole over another dish and inserted a marker into the hole and turned the dish 360 degrees to get a location mark on the bottom of the dish. I then folded a piece of paper in half then a folded the paper again to 90 degree intersecting creases in the paper. Then I measured the diameter across the center of the dish from line to line. Divide this measurement by 2. I measured this from the center out on the folded paper creases, marked the paper, the points are the outer points of a square, and will be used as a template to mark the holes in the bottom for the SS all-thread. It is critical that these four holes are located right.

The holes I have now in these are two 1/4 in holes horisontally in the photo and two 3/8 holes vertical in this photo. The all-thread size will determine the size of the small holes.I will be drilling the larger ones out to 1/2 or 5/8 I,ll decide that later.

Sorry... No description for this picture at this time.

The picture name is: 111406 0024.jpg

This is what I want to see. Also the dishes are very thin I think around 4 mm. thick. Have to take time drillin these to do a good job.I placed them over a small block of wood (backer)and used a drill press.

another shot of the desired alignment.

Proceed to another page of the Large Bell Stack Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from Beshires1

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: November 18, 2006 12:39am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!