Foundry Project Page 3

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:04am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click Here to Re-Display the Main Project Page

I'm cutting my blower pipe on an angle so that it matches the lower end of the furnace. I got this tip from one of Lionel's pages. I hope it works well :)

Good god this sucks! Hacking this baby off was nasty ... ouch my arm.

Finally done. My wife took like 5 pictures of me doing it, but I figured why bore you with my pain :)

Poof... finished. Gotta love the internet.

Cutting the hole in the bucket here. I had to ensure that it will be at the right height by measuring and a bit of fudging (guessing). I want a tiny bit of an upward angle on my air pipe. I think it will help to swirl the air better. Perhaps not but it will only be a slight upward angle at most.