8 plate series cell Project Page 8

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: February 14, 2007 01:50am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from kumaran

Click Here to Re-Display the Main Project Page

Used fish tank bubbler to get fine bubbling.

This is how it looks after filled with water. The hose are just for testing. I plan to do torch testing so I'm using football needle as torch tip. I find it's hard to blow through fish tank bubbler. I may use some other material to replace fish tank bubbler later after testing. The whole unit takes only half an hour to build.

I was doing torch test to check if bubblers functions as intended (safety). The electrolyzer pumps out good amount of gas to get 2" of torch. Now, I cut the power off. The bubbler cap was too tight to pop off. So huge loud BANG causes the bubbler broke into pieces. My neighbours came out to check what happens.

I collected back all the pieces from few meters away from test area.