Submerged Cell Project Project Page 7

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: October 25, 2006 03:17am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from mos68x

Click Here to Re-Display the Main Project Page

I figured I'd use the 1 and 6 inch welding method here since I had bad warping problems on the tank.

Got all the parts welded up. I had to clamp it to the bottom flange since it was still off more than I wanted it to be. After I welded everything together the heat from the welding straightened it up and it mates fairly well.

Better shot again, stinkin light in here isn't enough so I have to rememeber to use the flash on the camera.

Nice close up to see the welds, lol. I'm really happy about this, FINALLY I don't have to clean up any of the welds, lol.