8 plate series cell Project Page 6

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: February 14, 2007 01:50am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from kumaran

Click Here to Re-Display the Main Project Page

I use lock nut (nylon) for press bolt. This is to minimize gas leakage from threaded area if any.

Anti slosh PVC sheet. Length 2" and width (29mm) is just nice to fit into slot.

Antislosh PVC in place.

Closer look.