Fuel Heater Project Page 3

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: March 28, 2007 01:07am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from kumaran

Click Here to Re-Display the Main Project Page

Inside SS fuel container.

I use T-connector previously and now changed to Y-connector to distribute or split hot fuel equally. Need to use fuel filter at both side to minimise fuel rush during high pressure. The concept works.

Another view of whole system.

This is new upgrade on fuel heater system. I have changed from SS container to plastic container. Haven't put for testing yet. The concept is much straight forward compared to previous version.

Fuel from container flows out from B1 into heater copper (rolled on exhaust). Heated fuel looped back to container by entering at T1. The purpose is just to heat the fuel.

Hot fuel flows out from B2 into carburetor. The fuel flow will be consistant and not over pressured like on previous setup.

T2 outlet is for fuel vapor which goes to air intake. I need to add another small container to trap liquid and just allow fume or gas into air intake.