Welcome to OUPower.com
"Over Unity Power" Research

Stacked Electrodes Project Page 3

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: March 19, 2007 09:31pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from Beshires1

Click Here to Re-Display the Main Project Page

Proceed to another page of the Stacked Electrodes Project: [<<<   <      >   >>>]

electrolizer with splash guard...

The splash guard will later be sealed down around the edges and along the top of the container partition.Also please note: I will install rubber hoses on each rod that will run from the inside of the container top ,thru collection chamber [above splash guard] passing thru the splash guard down inside the electrolite chamber to the top of the first bell. I always insulate any electrically charged rods that will pass thru the gas chamber.This splash guard is something new I had to come up with to keep the electrolite within their cells and prevent contact with other cells.

This is the top to the electrolizer. It shows the electrode hole layout. The two circled holes are being plugged ,their from another design. This cap was used from an earlier project. I,ll clean it up for later photos

Couldn,t resist takeing one with the top on. Still have to do more work before I'm ready to cap it. But all cell wireing will be outside the container.Also The 1" ring taken off the top cap, makes a fine base to set the canister on so it stands upright.

Testing one cell having unequal surface area.

Proceed to another page of the Stacked Electrodes Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from Beshires1

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: March 19, 2007 09:31pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!