Welcome to OUPower.com
"Over Unity Power" Research

Powering up Project Page 3

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: April 13, 2007 04:35am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from Beshires1

Click Here to Re-Display the Main Project Page

Proceed to another page of the Powering up Project: [<<<   <      >   >>>]

Connections from Rocker Switch to Dimmer to transformer

This is the Secoundary winding hook-up to the 25amp 50V Bridge Rectifier.Gotta run the DC output thru a filter capacitor, I think.

On the left of the back-end of the power supply notice the red switch?

Let there be light. At last, I got that dang switch figures out. It is a SPDT  lighted on off switch. Lets see ,Ok the top spade connection on the switch runs to primary connection on transformer. Also this wire has a splice wire runnin to the AC Mains on the power cord.. The middle post on the power switch is wired to one black wire on the dimmer switch, the other black wire on dimmer switch runs to the other post on the transformer primary.The bottom connection on the switch runs to the other AC Mains on the power cord.

This is a close up of the powercord connected to the back of the box. It kinda plugs into a small square hole I cut into the box and there are two male spade connectors protruding into the box, for Mains connections to be made. the screw you can see secures the plug onto the box. Look closely it is also the AC Mains ground connection. This power cord was salvaged from the same microwave oven as the transformer.

Proceed to another page of the Powering up Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from Beshires1

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: April 13, 2007 04:35am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!