H20 fuel Project Page 2

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:37am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from pirjar

Click Here to Re-Display the Main Project Page

borrowed a battery charger from our neighbor.

after 10seconds. drawing 7-8amps, water is cool.

This is my test idea. I havnt actually tested this design yet but seems promising.

Tap water is used for conditioning(removing impurities). How to condition the water, run the cell (open lid) with tap water for a few minutes (5 mins) everyday for 3-5 days, brown scum will form at the bottom, remove the brown scum then the clean water will be the fuel.

I tested also two stainless plates 5 cm apart but bubble formation is too slow, then tested at 2mm apart bubble formation is quite fast. This is done without any circuit just a 12v car battery.