Welcome to OUPower.com
"Over Unity Power" Research

Perspex Case Project Page 2

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: October 31, 2007 02:23pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from peterZA

Click Here to Re-Display the Main Project Page
Project Description:
Standard 15mm thick perspex case, if theres a next time, I wont be doing all the drilling and tapping on the sides and bottom, too much work and expense(6mm ss counter sink machine screws)

Proceed to another page of the Perspex Case Project: [<<<   <      >   >>>]

here is a closeup of the perspex cage I built on the lid to house some "aqua mat" splash protection.
thats a standard barbed 3/8 th's fitting from a compressor in the lid which was drilled, tapped and teflon taped, standard procedure for all threads on this project.

I was wondering how the whole shebang would look, so I popped in some plates to keep the aquarium mat up where its sposed to be. I havent yet figured out the auto water fill, gets tricky to maintain even distribution between all 119 cells...can leave that for the time being I spose.

A view with the lid off and the aqua mat in place. I also made small cages to hold the cutout pieces of mat which can be seen at the bottom of the pic....all in the interests of keeping the liquids in the case where they will do most good.

and thats pretty much all that can be said about the case side of things.

Here’s a close-up of a perspex join. Ideally you want it to be clear because those little bubbles spell trouble. Somehow or the other they join up to make a path for leaks, adding to those created by tapping and screwing the case, in the end I went the fish tank route and ran a small bead of silicone around the inside seams...just visible under the screws.

Proceed to another page of the Perspex Case Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from peterZA

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: October 31, 2007 02:23pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!