Welcome to OUPower.com
"Over Unity Power" Research

Honda Accord 1981 Project Page 2

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: June 2, 2008 12:43am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from kumaran

Click Here to Re-Display the Main Project Page

Proceed to another page of the Honda_Accord_1981 Project: [<<<   <      >   >>>]

Inside car.

Water/methanol injection unit. I use mini compressor to compress air around 40psi to 60psi into water/methanol mix container. Ball valve used to hold or release the pressurised water/methanol.

Fine spray of water/methanol mix.

Closer view of fine water/methanol spray.

Model : Honda Accord 1981
Engine capacity : 1800cc carburetored
Vehicle condition : Poor

I use this car totally for testing only. So far, I have tested fuel vapor system, water/methanol fine mist injection system, water/methanol vapor injection system and hydroxy system.

Proceed to another page of the Honda_Accord_1981 Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from kumaran

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: June 2, 2008 12:43am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!