Welcome to OUPower.com
"Over Unity Power" Research

Testing Bobs Design Project Page 2

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: October 9, 2006 10:14pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from Nerd_Weed

Click Here to Re-Display the Main Project Page
Project Description:
This is my setup to Bob Boyce concept of electrolysis.

Proceed to another page of the Testing Bobs Design Project: [<<<   <      >   >>>]

each disk + spacer will occupy 4,5mm(3mm spacer + 1,5mm from the disk) of the 15cm bolt so it can handle up to 30 discs

Its was harder then i thought to build in this setup becouse since the bolts cant touch the discs and i drilled the bolt hole a little far then it should.
This is just a demo of the 21 disks cell with 3 disks so i could prove to myself that the plastic/acrylic bases wasnt a waste of money.
i'll drill another hole in the center of the base so i can put another bolt to make the conection.

I think now i got the right concept of the bobs design... I had the top of the disk cutted and sandpaper it. Now i have 10 disks like this to test.

Now im using PVC sheets for the spacer. I Couldnt find a 1/8" thick so i got a 3,5mm. This is the unfinished spacer, i still have to cut the inside to make it an O-RING.
Since the diameter of this disk is so strange(3" 13/16), i couldnt find a tube to fit tight. So im going to seal it with hot silicon and then put in a bigger easy-to-find tube.

Proceed to another page of the Testing Bobs Design Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from Nerd_Weed

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: October 9, 2006 10:14pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!