Welcome to OUPower.com
"Over Unity Power" Research

Submerged Cell Project Project Page 15

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: October 25, 2006 03:17am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from mos68x

Click Here to Re-Display the Main Project Page

Proceed to another page of the Submerged Cell Project Project: [<<<   <      >   >>>]

Here you can see the bottom side of the connections. The bolts that I used were 3/8-16 one was 3/4in long and the other is 1 1/2in long I think, maybe 1 1/4in. The long bolt was dropped through the top with the grommet in place. There is a washer on the top side and on the bottom side of the sheet metal, with the grommet being crushed in-between. Like I said, I'm not happy with this design, but it's the best I have so far.

Here I put in the distilled water and showed the level where just over two gallons came to. I had about 1/2in of rainwater in the bottom, so it brought it just above the level of the cell.

Here is the first run off the solar battery. Not nearly as much production as I was expecting, however this is still good since there is no electrolyte in it at all right now.

Just wanted to show what the incoming voltage is off the battery. Yeah I know that it is not effecient, but I didn't have any more plates to put in as of right now.

I tried to get a reading for amps, but somethings not working right here and I'm not sure. I did put it on DC A and it still read nothing. I put the meter in series to the cell and the cell stoped working, so there's obviously something wrong with the multimeter setup.

Proceed to another page of the Submerged Cell Project Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from mos68x

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: October 25, 2006 03:17am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!