Clausing 6913 Lathe Project Page 14

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: July 29, 2011 11:48am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click Here to Re-Display the Main Project Page

Here's how deeply the bearing was cutting into the housing.

Here I have placed a thin steel washer in between my bearing and the housing. It's a nice snug fit onto the housing shoulder so now the only thing pushing on the housing is the washer. The bearing's inner race rides against the washer now. The outer race of the bearing does not push on anything on the outside anymore. Inside the "outer hub" the outer race is taking the load.

Final assembly in the configuration that my lathe came to me. It's close but apparently not correct. Hopefully someone can help me figure out how this should be properly configured.

side view of the setup.