Welcome to OUPower.com
"Over Unity Power" Research

Foundry Project Page 12

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:04am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click Here to Re-Display the Main Project Page

Proceed to another page of the Foundry Project: [<<<   <      >   >>>]

Some more ramming photos... about 1/2 way done here.

Done with the outside portion, now we have to make the floor... Yikes I don't think I'm going to have enough refractory mix left?!

Making it nice and smooth and packing it in there good and tight!

Starting to load up the bottom of the furnace. I have placed my little wooden "T" in the bottom so that it will burn out the "runoff trays" ...just in case of an accident.

Here my wife is being a sweetie. I did run out so we robbed a bit of sand from my daughter's sandbox. A bit of sifting, a little mixing and some water. Poof done. -Yes I know this didn't cure overnight like the rest, but for such a little amount, I don't think it will matter much. I hope not at least!

Proceed to another page of the Foundry Project: [<<<   <      >   >>>]

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:04am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!