Hi,
Am new here and am just getting started building a smacks booster. Have been doing all the searching I can and realize the smacks design isn't the best but its a good place to start. I have two questions if I may.
First, is the dimpling and sanding needed to be done on both sides of all plates or just the facing sides of the pairs?
Second question: It seems the heat is a big problem. It would seem that by adding a couple of floater pairs per side it would lower the pair voltage to a much more reasonable value therby lowering the heat dissipation. The problem then is where to put it. It won't fit in a 4" tube any more. What is the next size pvc or abs tube commonly available?
Has anyone tried this? Perhaps a 5"(if available) mounted horizontal.
Thanks in advance for any suggestions,
Tom