For Kumaran:
I'm not very sure if you are well versed with Stanley Meyer Technology.
I would be for one thing very impressed if you could generate anywhere close to the outputs mentioned with pulsed 12 Volts and HALF an AMP!!
Please donot confuse this with the regular high ampearage electrolysis. This is low ampearage high volage pulsed electrolysis!! wherein you use the voltage potential to break down the covalent bonds and by the way the water doesnt heat up as in the regular electrolysis. The temperature rise is at the most 3 - 4 deg above ambient after about half hour of working!!
If you take a closer look at the third video you would see large bubbles of the range of 4mmto 10mm+leaving the tubes, so dont go by the more visible slow moving smaller bubbles.
To SeaMonkey and MarkinAustralia :
I initially started off with Dave's circuit.....was in touch with him to sort out a few issues with the circuits the went on to make a few improvements. You could say that Dave's circuit was the skeleton where i started off but had to make some changes. Of the original circuit i had a few burnt/blown out components and low gas generation as my setup is with 9 tubes of 9 inch lengths and his was 6 tubes of 5 inch lengths so the exposed surface areas are comparitively higher. From what I presumed Stan used tubes of 18 inches so I went for half his length but the same number as in his video.
Material used is 316L seamless pipes. Annealed for 3 hours in inert amosphere of Argon to remove all residual magnetism and cold work stresses before they are assemled. Leads used are 316L 1.2mm dia wires to all 18 pipes individually spot welded. The inner pipe is 1/2 inch longer than the outer at the bottom for the setup for connections.
You need to be very patient with the conditioning of the pipes.....it took me months to get the generation you see.
Volts x Amps = Watts
12 x 0.51 = 6.12 watts the generation is around 7 cc/sec
which coverts to 16.776 Lits / hour
16.776 x 2.4 watts (Faraday/lit/hour generation) = 40.262 Watts
Well I seem to be generating the equivalent of 40.2 watts as per Faraday with just 6.12 Watts.........I hope this answers Kumaran's question aswell.
I dont know if im right but I seem to be generating 550% excess
as the above works out to 40.2/6.12 x 100 = 656.86%
656.86 - 100 (Faraday) = 556.86% OU !!
Correct me if im wrong with the calculations.
Alright now to the crux of the situ... I dont know how long i'll be allowed to post this stuff over the net as initialy when I was in touch with Dave I had sent some pics to him and my place was raided within a few hours after the mail to him. I was kind of helped out during this time by Dave and Patrick Kelly.Though ive had success a few months ago I had not come out in the open but now Ashtweth of Panaces Bocaf has convinced me to go public as this could save me any more future harassment.....Im taking a huge chance by posting this right now.... you can see more details of the problem at
http://www.panacea-bocaf.org/EngineerinIndia.htm
The above writeup is on a few other sites aswell. This had happened some time in Jan this year.
I'll try and post a few more videos using 12 Volts 1 amp 1.5 amp.... at the earliest and post the links. Try and save the vids incase theyre removed.