Welcome to OUPower.com
"Over Unity Power" Research

herby53 Project Page 1

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: January 20, 2007 06:06am
v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from herby53

Click Here to Re-Display the Main Project Page

Project Description:
I thought I try to put a project page together for every one to see what I am talking about in the forum.
I started experiementing with this theme in the late 1980s, exploring different materials from zinc,graphite in sheet and rod, SS rod & sheet and the possible result to create hydroxy.till 1997 I had to stay in verry limited space and verry strickt rules because living in a appartement does not give much room for real experiments.
The results was that all material did work but the most promissing in regards to gas output and required power was the stainless steel. then in 1999 I have build my house with a 1,000 sqfeet metal workshop in a rural area where I finally could experiementing.
sorry I have no pics from the old days.
A big break was as I needed emergency surgery because of colone cancer it putted everythings on hold for about a year.
My first couple experiements was then going to explore the different options of design in regards to vertical or horizontal there are a few picture about comparing both. then I came up with SS wire mesh to use tests had shown a much higher gasoutput with even less surface area.
My main goal is to create enough hydroxy to power my generators 1 with 10,000 Kw and 1 with 6 Kw.
the following experiements will be documented in more detail.

Proceed to another page of the herby53 Project: [<<<   <      >   >>>]


Sorry... No description for this picture at this time.

The picture name is: DOUBLECONE 001.jpg


Sorry... No description for this picture at this time.

The picture name is: DOUBLECONE 002.jpg


I did cut off the lower rim and the top rim with a rotozip then drilled 1/4 inch holes in the inner part and added two connector strips one on the outher what is original about 1 inch longer then the inner and one on theinner cup


here you can clearly see the three nylon spacer screws


Sorry... No description for this picture at this time.

The picture name is: cupcone4.jpg

Proceed to another page of the herby53 Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from herby53

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: January 20, 2007 06:06am
v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!